This is a
Factory OEM (Original
Equipment Manufacturer) 3 button keyless entry remote, aka
"key fob" for a 1997 Oldsmobile Cutlass.
These are genuine Oldsmobile OEM electronics in a
new aftermarket case.
1. Collect all remotes
that you wish to program. This procedure will erase all previously programmed
remotes. You must program all existing and new remotes that you wish to use on
the vehicle at this time.
2. Locate programming
connector on the passenger side of the trunk. Remove any trim or carpeting to
access the connector. Connector will be close to the tail light Connector is a
port connected to a black and white wire. Connector will not be connected to
3. Next you must jump the
programming connector. You may use a jumper wire or paper clip. First make
contact to the metal connector inside the port with the paper clip or wire.
Next touch the other end of the wire or paperclip to a metal surface of the car
4. Locks will cycle from
lock to unlock signaling entering of programming mode.
5. Press and hold lock and
unlock together on a remote. Locks will cycle again and this remote has been
successfully programmed. Repeat this step for any additional remotes.
6. Remove jumper wire or
paper clip to exit programming mode.