This is a
Factory OEM (Original
Equipment Manufacturer) 3 button keyless entry remote, aka
"key fob" for a 1998 Oldsmobile Cutlass.
These are genuine Oldsmobile OEM electronics in a
new aftermarket case.
1. Turn ignition off.
2. Locate programming
connector in the trunk. It is a plastic connector with two wires black and
white leading to it. The connector will not be connected to anything and will
be located in the center of the rear shelf.
3. Must jump the
connectors inside the two terminals of the programming connector. Use a jumper
wire or a bent paperclip. Locks will cycle to lock to unlock.
4. Hold lock and unlock on
the remote being programmed for 15 seconds. Locks will cycle again confirming
programming. Repeat for additional remotes.
5. Remove jumper wire or
clip to exit programming mode.