This is a new aftermarket replacement key fob compatible with Cadillac models listed below. This product meets our quality standards and is guaranteed to work the same as an original.

• 2013-2014 Cadillac ATS
• 2014 Cadillac ELR
• 2010-2015 Cadillac SRX
• 2013-July 2015 Cadillac XTS

1. Vehicle must be off.

2. Place the working remote(s) in the cupholder. Have the new remote with you.

3. Insert the key into the key lock cylinder located on the outside of drivers door.

4.Turn the key to the unlock position five times with in ten seconds.

5. The (DIC) Driver Information Center displays Ready to Learn Electronic key #2, 3, 4 ETC.

6. Place the new remote into the transmitter pocket with the buttons facing the front of the vehicle. (The transmitter pocket is inside the center console between the driver and front passenger seats). The storage area will need to be opened and the storage tray lifted up to access the transmitter pocket.
7. Press the ignition. When the remote is learned the DIC display will show that it is ready to program the next remote.

8. Remove the remote from the transmitter pocket and press unlock on the remote. To program additional remotes, repeat Steps 6 through 8.

9. When all additional transmitters are programmed, press and hold the ignition for ten seconds to exit programming mode.

1. The vehicle must be off.

2. Insert the key into the key lock cylinder located on the outside of drivers door.

3.Turn the key to the unlock position five times with in ten seconds.

4. The (DIC) Driver Information Center displays REMOTE LEARN PENDING, PLEASE WAIT.

5. Wait for ten minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN and then press the ignition. The DIC displays will again show REMOTE LEARN PENDING, PLEASE WAIT.

6. Repeat Step 5 two additional times. After the third time all previously known remotes will no longer work with the vehicle. Remaining remotes can be relearned during the next steps. The DIC display should now show READY FOR REMOTE #1

7. Place the new remote into the transmitter pocket with the buttons facing the front of the vehicle. (The transmitter pocket is inside the center console between the driver and front passenger seats). The storage area will need to be opened and the storage tray lifted up to access the transmitter pocket.

8. Press the ignition. When the remote is learned the DIC display will show that it is ready to program the next remote.

9. Remove the remote from the transmitter pocket and press unlock on the remote.

10. To program additional remotes, repeat Steps 7 through 9.

11. When all additional transmitters are programmed, press and hold the ignition for ten seconds to exit programming mode.

An aftermarket remote or key is a product that is not associated with the brand of your vehicle. Because of this, they tend to be a bit cheaper than remotes and keys that come from your vehicle's manufacturer.

An aftermarket product will still sync up to your vehicle and work just like a regular remote or key, it just won't have your vehicle's logo.