2000 Honda Odyssey Key Fob Remote Programming Instructions

Here are the programming instructions for a 2000 Honda Odyssey Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at Keylessentryremotefob.com You can also leave comments or suggestions at the bottom of this blog. If you like what we provide please forward on to your friends & family and share via the social media icons below; people like you are our best advertising tool! 

ORDER THIS KEY FOB PART NUMBER HERE:  A269ZUA101



2000 EX Model with Factory Installed Keyless Entry System.
2000 EX Model with Dealer Installed Keyless Entry Ststem.

 Note:
 This system will accept up to three remotes. The remotes are stored in a 
 stacking-type memory. If a fourth remote is programmed  the first remote
 will be erased.

 1. Turn ignition switch to ON (II)

 2. Within 4 seconds  press the LOCK or UNOCK button on one of the remotes.
     Make sure remote is aimed at the reciever near the glove box.

 3. Within 4 seconds turn ignition switch to LOCK (0)

 4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used
     in step 2

 5. Within 4 seconds turn the ignition switch to ON (II)

 6. Within 4 seconds press the LOCK or UNLOCK button the same remote.  Make
     sure the power doorlocks cycle to confirm you are in programming mode.
     Presss the LOCK or UNLOCK buton again.

 7. Press the LOCK or UNLOCK button on each remote you want to program. Make
     sure door locks cycle after you push each remote button to confirm system has
     accepted the remote.

  8. Turn the igniton switch to LOCK (0) to exit programming mode.

  9. Test remote(s)

      Disclaimer

 2000 LX Model with Dealer Installed Keyless Entry System.

1. Turn ignition switch to ON (II)
 2. Press the LOCK or UNOCK button on one of the remotes. (An unprogrammed
     remote can be used for this step.)

 3. Turn ignition switch to LOCK (0)

 4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used
     in step 2

 5. Turn the ignition switch to ON (II)

 6. Press the LOCK or UNLOCK button the same remote.  Make sure the power door
     locks cycle to confirm you are in programming mode.

 7. Press the LOCK or UNLOCK button on each remote you want to program. Make
     sure door locks cycle after you push each remote button to confirm system has
     accepted the remote.

  8. Turn the igniton switch to LOCK (0) to exit programming mode.

  9. Test remote(s)


Was This Information Useful?  Please take a moment to Like / Follow us and share via social media below. It is people like you that help spread the word about us.  It helps so much!  Thanks for visiting and sharing with your friends and family!