Here are the programming instructions for a 2003 Mitsubishi Eclipse Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at Keylessentryremotefob.com You can also leave comments or suggestions at the bottom of this blog. If you like what we provide please forward on to your friends & family and share via the social media icons below; people like you are our best advertising tool!
ORDER THIS KEY FOB PART NUMBER HERE: HYQ12ABA
1. Locate
the Data Port under drivers side dashboard usually located to the right of
steering column.
2. Insert keys in ignition and leave in the OFF position.
2. Insert keys in ignition and leave in the OFF position.
3. Make sure there are metal contact pins in terminals 1 and 4 and
connect the Data Port terminals 1 and 4 with a suitable
jumper wire, leave the jumper wire connected throughout the programming
procedure. Make sure you
know which terminals are 1 and 4.
know which terminals are 1 and 4.
4. Within 10 seconds after connecting the jumper wire, press the Hazard
Switch 6 times. Note: The doors will
automatically lock and unlock once at this time indicating that the system is in the programming mode.
automatically lock and unlock once at this time indicating that the system is in the programming mode.
5. Press the LOCK button on the remote to be registered
three times within 10 seconds. Upon successful
programming, the door will lock and unlock once.
programming, the door will lock and unlock once.
6.
Repeat step 5 with up to 4 remotes (including any existing
remotes) within one minute. After completing each
programming, the doors will lock and unlock once.
programming, the doors will lock and unlock once.
7.
Disconnect the programming wire and remove the keys from the ignition.
Subscribe To Our Social Networks For Special Discounts, Offers, & Contests!
By Keyless Entry Remote Inc
