Here are the programming instructions for a 2009 Honda Odyssey Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at Keylessentryremotefob.comYou can also leave comments or suggestions at the bottom of this blog. If you like what we provide please forward on to your friends & family and share via the social media icons below; people like you are our best advertising tool!
ORDER THIS KEY FOB PART NUMBER HERE: OUCG8D-399H-A
Have all
remotes for the vehicle on hand. Make sure all the doors and rear
hatch/trunk are closed during programming.
hatch/trunk are closed during programming.
Only
need to use 1 remote to get into program mode but all remotes must
be programmed during the same session. Each step must be completed
within 5 seconds.
be programmed during the same session. Each step must be completed
within 5 seconds.
1. Sit in the car with
all doors/trunk tightly closed
2. Turn the key to the
ON position, marked by "II" on the ignition bezel
so the dash lights come on, then within 5 seconds press the
"Lock" button on the remote for 1 second or so and release the
button.
so the dash lights come on, then within 5 seconds press the
"Lock" button on the remote for 1 second or so and release the
button.
3. Turn the key to the
OFF position, marked by "I" on the ignition
bezel - dash lights go off.
4. Repeat steps 2 & 3 three more times (A total of 4 times) – each step
must be done within 5 seconds of the previous step.
bezel - dash lights go off.
4. Repeat steps 2 & 3 three more times (A total of 4 times) – each step
must be done within 5 seconds of the previous step.
5. Upon the 4th turning
of the key to "ON", press the lock button on
one remote, the locks will make a cycling sound (clunk), locks will
NOT lock or unlock at this point, they will just make a noise. The
system is now in programming mode. Do not turn key off.
one remote, the locks will make a cycling sound (clunk), locks will
NOT lock or unlock at this point, they will just make a noise. The
system is now in programming mode. Do not turn key off.
6. Within 5 seconds of
entering programming mode and within 5
seconds of each other, press the lock button ON EACH remote
you are programming, for a second or so and release. This step
needs to be completed within 10 seconds. Each time a remote
button is pushed, the locks should cycle. Up to 3 remotes can be
programmed.
seconds of each other, press the lock button ON EACH remote
you are programming, for a second or so and release. This step
needs to be completed within 10 seconds. Each time a remote
button is pushed, the locks should cycle. Up to 3 remotes can be
programmed.
7. Turn ignition
completely off and remove the key. Step out of car
and close door. The remotes should be programmed and should
work. If you have a trunk/hatch release, the button for this feature
needs to be held for a few seconds before the trunk/hatch will
"pop".
and close door. The remotes should be programmed and should
work. If you have a trunk/hatch release, the button for this feature
needs to be held for a few seconds before the trunk/hatch will
"pop".
Subscribe To Our Social Networks For Special Discounts, Offers, & Contests!
By Keyless Entry Remote Inc
