1993 Infiniti J30 Key Fob Remote Programming Instructions

Here are the programming instructions for a 1993 Infiniti J30 Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at Keylessentryremotefob.com You can also leave comments or suggestions at the bottom of this blog and if you like what we provide please forward on to your friends & family; people like you are our best advertising tool!

ORDER THIS KEY FOB PART NUMBER HERE: A269ZJA073



Note: The horn chirp can be disable by pressing the lock and unlock buttons simultaneously until the hazard lights flash, and no enable press the lock and unlock until the horn chirp.

Instructions

1.  Close all doors and lock all doors

2.  From the door switch unlock the trunk

3.  Insert and remove the key from the ignition key cylinder more than six times within 10 seconds.
NOTE:Key should be withdrawn from ignition key cylinder completely each time.
NOTE:Do not rush the insertion/removal key cycling process. The side marker/tail/license lamps and interior illumination will flash twice when this step is accurately completed.
NOTE:At this time, the new ID code is entered and original (previous) ID codes are erase.
4Manually unlock and lock the driver side door

5.  Push any button on the new remote controller once.
NOTE:If there is only one remote controller skip step 6.

6.  Additional ID code entry Repeat step 4 and 5.

7.  END.

NOTE:If you need to activate more than two additional new remote controllers, repeat the procedure on step 6 "Additional ID code entry" for each new remote controller.
NOTE:Entry of maximum four ID codes is allowed and any attempt to enter more will be ignore.

Was This Information Useful?  Please take a moment to Like / Follow us and share via social media below. It is people like you that help spread the word about us.  It helps so much!  Thanks for visiting and sharing with your friends and family!