Here are the programming instructions for a 1998 BMW Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at Keylessentryremotefob.com You can also leave comments or suggestions at the bottom of this blog and if you like what we provide please forward on to your friends & family; people like you are our best advertising tool!
Each remote transmitter had a unique ID code and the car can store up to 4 ID codes.
Preparation
1. Close all doors,trunk,and hood.
2. The security system must be in disarm mode and key must be removed from the ignition key slot.
Enter Code learning mode
3.Open trunk and leave it opened.
4. open the driver's door and sit in the driver's seat
5. Close the driver's door.
6. Cycle ignition switch 5 times between Off and On (DO NOT START ENGINE)
The red status light will illuminate continuously, and the siren will chirp once to indicate that the code learning mode has been initiated.
The ignition switch cycling must be performed within 10 seconds.
The sequence in steps 1-6 must be performed within 45 seconds.
Register/Delete ID Code(s)
7. Open driver's door (remain seated in driver's seat)
8. Close driver's door
9. Press and release any button on the remote you wish to register into the system. The status led will shut off momentarily to indicate that one id code has been registered.
10. Repeat steps 7 to 9 to register the remain the ID codes.
Exiting code learning mode
11. Open driver's door and exit vehicle, leaving the door open.
12. Close trunk.
13. Close dirver's door. The LED will turn off and the siren will chirp once twice.
14. The initialization procedure is now completed; test all remotes to confirm operation.Was This Information Useful? Please take a moment to Like / Follow us and share via social media below. It is people like you that help spread the word about us. It helps so much! Thanks for visiting and sharing with your friends and family!
Each remote transmitter had a unique ID code and the car can store up to 4 ID codes.
Preparation
1. Close all doors,trunk,and hood.
2. The security system must be in disarm mode and key must be removed from the ignition key slot.
Enter Code learning mode
3.Open trunk and leave it opened.
4. open the driver's door and sit in the driver's seat
5. Close the driver's door.
6. Cycle ignition switch 5 times between Off and On (DO NOT START ENGINE)
The red status light will illuminate continuously, and the siren will chirp once to indicate that the code learning mode has been initiated.
The ignition switch cycling must be performed within 10 seconds.
The sequence in steps 1-6 must be performed within 45 seconds.
Register/Delete ID Code(s)
7. Open driver's door (remain seated in driver's seat)
8. Close driver's door
9. Press and release any button on the remote you wish to register into the system. The status led will shut off momentarily to indicate that one id code has been registered.
10. Repeat steps 7 to 9 to register the remain the ID codes.
Exiting code learning mode
11. Open driver's door and exit vehicle, leaving the door open.
12. Close trunk.
13. Close dirver's door. The LED will turn off and the siren will chirp once twice.
14. The initialization procedure is now completed; test all remotes to confirm operation.Was This Information Useful? Please take a moment to Like / Follow us and share via social media below. It is people like you that help spread the word about us. It helps so much! Thanks for visiting and sharing with your friends and family!
Subscribe To Our Social Networks For Special Discounts, Offers, & Contests!
By Keyless Entry Remote Inc
