2004 Chevrolet Suburban Key Fob Remote Programming

Here are the programming instructions for a 2004 Chevrolet Suburban Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at Keylessentryremotefob.com You can also leave comments or suggestions at the bottom of this blog. If you like what we provide please forward on to your friends & family and share via the social media icons below; people like you are our best advertising tool! 

ORDER THIS KEY FOB PART NUMBER HERE:  15186200



1.      Close all vehicle doors.
2.      Insert the key into the ignition.  

3.      Hold down the power UNLOCK button on the driver’s door panel-continue to hold
      down until instructed to release in step 9.

4.      Perform steps 5 through 8 in fairly rapid succession.

5.      Turn the ignition switch to the ON position (as far as you can go without starting the
      engine).

6.      Turn the ignition switch to the OFF position.

7.      Turn the ignition switch to the ON position.

8.      Turn the ignition switch to the OFF position.

9.      Release the power unlock button on the door panel. The vehicle will lock and unlock
      the doors automatically.  

10.  Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until
      the door locks and unlocks.
      This step may take up to 30 seconds.  

11.  Repeat step 10 NOW for each additional transmitter (including any existing
      transmitters).  

12.  Turn the ignition switch to the ON position in order to exit the transmitter programming
      mode.


Was This Information Useful?  Please take a moment to Like / Follow us and share via social media below. It is people like you that help spread the word about us.  It helps so much!  Thanks for visiting and sharing with your friends and family!