1999 Toyota 4Runner Key Fob Remote Programming Instructions

Here are the programming instructions for a 1999 Toyota 4Runner Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at Keylessentryremotefob.com You can also leave comments or suggestions at the bottom of this blog and if you like what we provide please forward on to your friends & family; people like you are our best advertising tool!

ORDER THIS KEY FOB PART NUMBER HERE: HYQ1512Y



1. Start with key out of ignition, drivers door is open all others closed and
    drivers door is unlocked.

2. Insert key into the ignition (Do NOT Turn) and Pull key out.

3. Perform these steps within 40 seconds.
    A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles
        starting with lock. Use an even pace and try to go about one cycle per second.
        (1Cycle  = 1 lock and 1 unlock).
    B. Close, then open drivers door.

4. Perform these steps within 40 seconds.
    A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles
        starting with lock. Use an even pace and try to go about one cycle per second.
         (1Cycle  = 1 lock and 1 unlock).
    B. Insert the key in the ignition cylinder.
    C. Turn the ignition to ON (Do NOT Start) then back to OFF once to program remote
         while retaining the orginal remote codes. Twice to erase all orginal codes and
         add new remote. Three times to check how many remotes are programmed or
         five times to erase all original codes.
    D. Remove the key from the ignition.

5. Within 3 seconds the power door locks should cycle automatically indicating successful
    entry into programming mode. Return to step 1 if the locks do not cycle at this point.

6. Perform these steps within 40 seconds.
    A. Press the lock and unlock buttons on the remote simultaneously for 1 second.
    B. Immediately after letting go of the lock and unlock buttons, press the lock button by
        itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle once
        indicating successful programming. If the door locks do not cycle, or cycle twice.
        repeat steps A and B in step 6 as your remote has not been accepted.
    C. Repeat steps A and B in step 6 for each new remote.

7. Close drivers door.



Was This Information Useful?  Please take a moment to Like / Follow us and share via social media below. It is people like you that help spread the word about us.  It helps so much!  Thanks for visiting and sharing with your friends and family!