Here are the programming instructions for a 2000 Honda Passport Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at Keylessentryremotefob.com You can also leave comments or suggestions at the bottom of this blog and if you like what we provide please forward on to your friends & family; people like you are our best advertising tool!
ORDER THIS KEY FOB PART NUMBER HERE: HYQ1512R-210
1. Open the driver’s door.
2. Insert key into ignition.
3. Turn the ignition switch to the ACC position and then to the LOCK
position three times. (This step must be completed within 3
seconds – go as fast as you can, or the system will not enter the
programming mode.)
4. Within 10 seconds, close and open the door two times.
5. Turn the ignition switch to the ACC position and then to the LOCK
position ***three times (again, do this within 3 seconds.)
6. Within 10 seconds, close and open the door. Verify that the power
door locks cycle once to confirm that the system is in
programming mode.
7. Within 20 seconds, press the LOCK button on the transmitter you
are programming. Verify that the door locks cycle once.
8. Within 20 seconds, press the UNLOCK button on the transmitter.
Verify that the door locks cycle once to confirm that the system has
accepted the transmitter’s code.
9. Repeat steps 7 and 8 for each transmitter to be added.
10. Remove key from ignition.
*** Some Passports require you to turn ignition on and off 5 times in step 5
Was This Information Useful? Please take a moment to Like / Follow us and share via social media below. It is people like you that help spread the word about us. It helps so much! Thanks for visiting and sharing with your friends and family!
Subscribe To Our Social Networks For Special Discounts, Offers, & Contests!
By Keyless Entry Remote Inc
