1995 Cadillac Seville Key Fob Remote Programming Instructions

Here are the programming instructions for a 1995 Cadillac Seville Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at Keylessentryremotefob.com You can also leave comments or suggestions at the bottom of this blog and if you like what we provide please forward on to your friends & family; people like you are our best advertising tool!

ORDER THIS KEY FOB PART NUMBER HERE: 10269729



1. Collect all remotes that you wish to program. This procedure will erase all previously programmed
remotes. You must program all existing and new remotes that you wish to use on the vehicle at this
time.

2. Insert key into ignition and turn it to the on position. Do not start the car.

3. Access programming connector in the trunk of the car. It will be located next to the latch for the trunk
lid. There will be a single wire running to a connector. The connector will not be connected to anything.
Sure a jumper wire or paper clip to jump the connector. Touch the clip or wire to the inside of the
connector and to a bare metal surface of the car to ground the connection. Locks will cycle from lock to
unlock to signal entering on programming mode.

4. Press the unlock button on the remote being programmed twice. Locks will cycle again confirming
successful programming. Repeat this step for additional remotes.

5. Remove jumper wire to exit programming mode.


Was This Information Useful?  Please take a moment to Like / Follow us and share via social media below. It is people like you that help spread the word about us.  It helps so much!  Thanks for visiting and sharing with your friends and family!