1997 Chevrolet Suburban Key Fob Remote Programming Instructions

Here are the programming instructions for a 1997 Chevrolet Suburban Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at Keylessentryremotefob.com You can also leave comments or suggestions at the bottom of this blog and if you like what we provide please forward on to your friends & family; people like you are our best advertising tool!


ORDER THIS KEY FOB PART NUMBER HERE: 21997127





1.   Locate the Data Link Port. It is located under dash drivers side. Be sure you know
     which pins are 8 and 4.

(Note port is wider at top) Your OBDII port will not
    have numbers, use this diagram for reference.
 
 


2.      Make sure there are metal contact pins in terminals 8 and 4. Connect 8 to 4 with a
        suitable jumper wire (leave the jumper wire connected throughout the programming
        procedure). Make sure you know which terminals are 8 and 4. The vehicle will respond
        by locking and unlocking the doors to signify entering of programming mode.
3.      Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to
       be programmed. After about 15 seconds, the vehicle will respond by locking and
       unlocking the doors. Release the buttons on the transmitter.

4.      Within one minute, repeat the previous step on the remaining transmitters to be
       programmed.

5.    Remove jumper wire applied to the OBDII Port.


Was This Information Useful?  Please take a moment to Like / Follow us and share via social media below. It is people like you that help spread the word about us.  It helps so much!  Thanks for visiting and sharing with your friends and family!