Here are the programming instructions for a 1997 Pontiac Grand Am Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at Keylessentryremotefob.com You can also leave comments or suggestions at the bottom of this blog and if you like what we provide please forward on to your friends & family; people like you are our best advertising tool!
ORDER THIS KEY FOB PART NUMBER HERE: 16245100-29
1. Make sure ignition is in the OFF position.
2. Locate the programming connector in the trunk (drivers side). It is a plastic
connector with two wires leading up to it. The connector is not plugged into
anything. You may have to pull back trim to access connector.
3. The programming connector should have two terminals. Connect both terminals
with a suitable jumper wire. Make sure the terminals remain connected
throughout the programming procedure.
4. Press the LOCK and UNLOCK buttons on the remote simultaneously. In response
the Keyless Entry Module will cycle all the Door Lock Motors at once. Your new
remote has been accepted and all existing remotes have been erased.
5. Repeat the previous step for each additional remotes (including any exsisting remotes)
Do not remove jumper wire in between programming of remotes.
6. Remove the jumper wire from the Keyless Remote Connector.
Having trouble programming the remote or just want a professional to program the remote for you? Enter your city or zip code in the search box below to find a professional key fob installer in your area.
ENTER YOUR CITY NAME OR ZIP CODE TO FIND A
PROFESSIONAL KEY FOB INSTALLER NEAR YOU
Subscribe To Our Social Networks For Special Discounts, Offers, & Contests!
By Keyless Entry Remote Inc
