Here are the programming instructions for a Toyota RS3000 Key Fob Remote. If you need an extra Key Fob or Replacement Fob for any vehicle you might have visit us at Keylessentryremotefob.com You can also leave comments or suggestions at the bottom of this blog. If you like what we provide please forward on to your friends & family and share via the social media icons below; people like you are our best advertising tool!
Programming Instructions:
First you will need to find the ECU for the alarm/keyless RS3000 System. It's usually located under the drivers seat. If it's not there, call your local Dealer's Service department and ask them where to find it.
Looking at the side with connectors on it, there should be a small button or hole on the right-hand side. You will need to press the button or insert a paper clip into the hole to press the switch inside, following the instructions below.
1. Insert key into the ignition switch and turn to "ON"
2. Press and hold the ECU's programming switch for 3 seconds. The status Monitor LED turns on for 5 seconds.
YOU MUST PREFORM THE NEXT STEP WITHIN 5 SECONDS!
3. Press and release the remote control's top or bottom button (whichever one you want to operate the system). The Status Monitor LED turns off The Piezo "chiper" Chirps once. The Exterior Lights flash once.
4. Turn off the ignition. The ECU will now operate with the remote just programmed.
Having trouble programming the remote or just want a professional to program the remote for you? Enter your city or zip code in the search box below to find a professional key fob installer in your area.
ENTER YOUR CITY NAME TO FIND A
PROFESSIONAL KEY FOB INSTALLER NEAR YOU
Programming Instructions:
First you will need to find the ECU for the alarm/keyless RS3000 System. It's usually located under the drivers seat. If it's not there, call your local Dealer's Service department and ask them where to find it.
Looking at the side with connectors on it, there should be a small button or hole on the right-hand side. You will need to press the button or insert a paper clip into the hole to press the switch inside, following the instructions below.
1. Insert key into the ignition switch and turn to "ON"
2. Press and hold the ECU's programming switch for 3 seconds. The status Monitor LED turns on for 5 seconds.
YOU MUST PREFORM THE NEXT STEP WITHIN 5 SECONDS!
3. Press and release the remote control's top or bottom button (whichever one you want to operate the system). The Status Monitor LED turns off The Piezo "chiper" Chirps once. The Exterior Lights flash once.
4. Turn off the ignition. The ECU will now operate with the remote just programmed.
Having trouble programming the remote or just want a professional to program the remote for you? Enter your city or zip code in the search box below to find a professional key fob installer in your area.
ENTER YOUR CITY NAME TO FIND A
PROFESSIONAL KEY FOB INSTALLER NEAR YOU
By Keyless Entry Remote Inc
